TECB250C - 5 Tonne 2 Post Clear Floor Hoist

TECB250C - 5 Tonne 2 Post Clear Floor Hoist

$0.00
Add To Cart
TECB250C - 5 Tonne 2 Post Clear Floor Hoist

TECB250C - 5 Tonne 2 Post Clear Floor Hoist

TECB250C - 5 Tonne 2 Post Clear Floor Hoist

The Tecalemit two post clear floor hoist is designed with the professional mechanic in mind.

With a 5 tonne lifting capacity and featuring a clear floor design, the hoist easily caters for a wide range of vehicles from small passenger cars, light commercial, low clearance and off road recreational vehicles.

The TECB250C utilises a clear floor design allowing space for easy cleaning, room for ancillary equipment and reduced risk of tripping hazards.

The hoist is equipped with a pre-set loading limit to avoid overloading and an Aluminium motor to protect from heat damage.

The hoist features:

  • Aluminium motor to avoid heat damage.

  • Pre-set loading limit to avoid overloading.

  • 24V top limitation switch prevents damage to roof of vehicle.

  • Adjustable lifting pads with a minimum height of 120mm.

  • Pick up pad extenders to increase the pad height, ideal for off-road vehicles.

  • Three stage lifting arms.

  • IP54 ABS control box, 24V operation.

  • Door protection rubber pad.

  • Integrated pick up pad holders.

  • Toe protection.

  • Compliance with Australian Standard AS1418.9:1996.

Technical Specifications.

  • Lifting Capacity: 5000kg

  • Maximum Lift Height: 1880mm

  • Minimum Pad Height: 120mm

  • Inside Column Width: 3342mm

  • Electric Motor: 3 Phase 415V

  • Lifting Time: 50 seconds

  • Minimum Concrete Thickness*: ≥120mm 20,7MPa Reinforced

  • Recommended Anchor Bolt: Ramset TruBolt M16x125

  • Drill Hole Diameter: 16mm

  • Drill Hole Depth: 100mm

  • Tightening Torque: 150Nm

Optional Extras

  • 240V Single Phase electric motor.

  • 95102000205 Chassis engagement adapter. Suitable for use on box chassis construction of north American trucks that often have a waxed frame.

Spare Parts Support

Tecalemit stock a comprehensive supply of spare parts for all our hoists to ensure minimal downtime.

With experienced staff on-hand to offer technical advice on all aspects, from hoist selection, installation, operation and on-going service and maintenance.

*NOTE: The lift should be installed on a smooth and solid concrete surface with its strength more than 3000psi (20.7MPa) with a minimum thickness of 120mm.