TECB242C - 4.2 Tonne 2 Post Clear Floor Hoist
TECB242C - 4.2 Tonne 2 Post Clear Floor Hoist
TECB242C - 4.2 Tonne 2 Post Clear Floor Hoist
The Tecalemit two post clear floor hoist is designed with the professional mechanic in mind.
With a 4.2 tonne lifting capacity and featuring an asymmetrical design, the hoist easily caters for a wide range of vehicles from small passenger cars, light commercial, low clearance and off road recreational vehicles.
The TECB242C utilises a clear floor design allowing space for easy cleaning, room for ancillary equipment and reduced risk of tripping hazards.
The hoist is equipped with a pre-set loading limit to avoid overloading and an Aluminium motor to protect from heat damage.
The hoist features:
Aluminium motor to avoid heat damage.
Pre-set loading limit to avoid overloading.
Adjustable lifting pads with a minimum height of 90mm.
Pick up pad extenders to increase the pad height, ideal for off-road vehicles.
Two stage long and three stage short lifting arms.
IP54 ABS control box, 24V operation.
Door protection rubber pad.
Integrated pick up pad holders.
Toe protection.
Compliance with Australian Standard AS1418.9:1996.
Technical Specifications.
Lifting Capacity: 4200kg
Maximum Lift Height: 1880mm
Minimum Pad Height: 90mm
Inside Column Width: 2850mm
Electric Motor: 3 Phase 415V
Lifting Time: 50 seconds
Minimum Concrete Thickness*: ≥120mm 20,7MPa Reinforced
Recommended Anchor Bolt: Ramset TruBolt M16x125
Drill Hole Diameter: 16mm
Drill Hole Depth: 100mm
Tightening Torque: 150Nm
Optional Extras
240V Single Phase electric motor.
95102000204 Chassis engagement adapter. Suitable for use on box chassis construction of north American trucks that often have a waxed frame.
Spare Parts Support
Tecalemit stock a comprehensive supply of spare parts for all our hoists to ensure minimal downtime.
With experienced staff on-hand to offer technical advice on all aspects, from hoist selection, installation, operation and on-going service and maintenance.
*NOTE: The lift should be installed on a smooth and solid concrete surface with its strength more than 3000psi (20.7MPa) with a minimum thickness of 120mm.